This photo shows the framework required for building the hull upright.
Roberts 53
This R 53 multi chine steel yacht has been built in Australia
and is due to
be launched in 2003. These photo's are courtesy of Dave and Roslyn, the owner builders.
| Page 1...... | Framing and plating the hull |
| Page 2...... | Fitting the deck and superstructure |
| Page 3...... | Fitting out the Cabins |
| Page 4...... | Fitting out the Galley and Dinette area |
| Page 5...... | Fitting out the Salon area |
Page 1 : Framing and plating the hull upside down.
This photo shows the framework required for building the hull upright.
The frames hanging from the joists with chine bars in place.
The keel plated. Stringers let into the frames.
The same stage from the rear of the vessel.
Transom plated.
Bottom plates added.
The same stage, taken from the transom..
Inside the vessel showing the frames and stringers lying against the hull.
Deck Beams added.
The hull fully plated.
Page [ 1 ] [ 2 ] [ 3 ] [ 4 ] [ 5 ]